Please retain product label and instructions for future reference
P 11
40mm
screw
Pre drill
hole
*
Cut to fit
Step 17
Parts needed - No. 40 QTY 92
Place the first two roof
board’s (No. 40) onto the log cabin
on each side, making sure the
boards are flush to the end of the
roof purlin. Once in position fix to
each purlin using 3x40mm screws.
Use the spacer (No. 43) to create an
expansion gap between each roof
board if installing during low levels
of moisture (summer). This creates
an expansion gap for the boards to
move into during high levels of
moisture (winter).
Once in position fix to each purlin
using 3x40mm screws.
You have been issued with 92 roof
boards, but in reality you may only
need to use 90
*Ensure the roof boards meet at
the top of the apex and leave an
overhang at the bottom.
Continue adding the roof boards
along the roof, fixing each one into
position using 3x40mm screws,
making sure that each board is
interlocked, flush at the bottom &
meet at the top of the apex.
The last board on each side
will overhang: Using a straight edge
and a pencil mark out a line as
a guide.
Cut along the pencil mark and
remove the excess. Place the cut
down board’s back onto the roof
and secure into place using
3x40mm screws per board.
276x40mm Screws
a
b
IMPORTANT:
Pre-drill before fixing screws.
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in product.
Nevertheless the process of
cutting and fitting the last roof
board(s) is the same.
b
23b
40
40
a
Step 18
Parts Needed - No. 35 QTY 4
Ensuring the roof boards are flush
at the overhanging side and meet
at the apex, fix the eaves frames
(No. 35) to the underside of the roof
boards using 9x30mm screws as
shown in the illustration
*Please Note:
This image is for
illustrative purposes and may
differ from your choice in
product. Nevertheless the process
of fixing the eaves frames is the
same.
18x30mm Screws
30mm
screw
Pre drill
hole
IMPORTANT:
Pre-drill before fixing screws.
35
