Mercedes-Benz Sprinter 2019, Руководство по эксплуатации

Страница: 230 / 298

R
the fastenings of the spare wheel bracket.
Replace the tires after six years at the latest,
regardless of wear. This also applies to the spare
wheel.
%
If you have installed a spare wheel, the tire
pressure monitoring system will not function
for this wheel. The spare wheel is not equip‐
ped with a sensor for the tire pressure moni‐
toring system.
Installing/removing the spare wheel
Vehicles with rear wheel drive: removing the
spare wheel (Cargo Van/Passenger Van)
Bolt covers for the safety hooks (example: Cargo
Van)
#
Open the rear-end doors.
#
Place a screwdriver into recesses 2 and
then pry off covers 1 .
#
Using the lug wrench from the vehicle tool kit,
unscrew the now visible bolts counter-clock‐
wise by approximately 20 turns.
#
Slightly raise spare wheel carrier 4 and
unhook left-hand safety hook 3 .
#
Assemble the pump lever for the jack and
slide it into sleeve 5 on the right-hand side
of spare wheel carrier 4 .
#
Raise spare wheel carrier 4 with the pump
lever and unhook right-hand safety hook 3 .
#
Slowly lower spare wheel carrier 4 to the
ground.
#
Lift spare wheel carrier 4 slightly and pull
the pump lever out of the sleeve.
#
Use the pump lever to lift the spare wheel
beyond the rear edge of spare wheel carrier
4 .
#
Carefully remove the spare wheel from spare
wheel carrier 4 . The spare wheel is heavy.
When the spare wheel is removed, the center
of gravity changes due to the heavy weight of
the wheel. The spare wheel may slip down or
tip over.
Vehicles with rear wheel drive: installing the
spare wheel (Cargo Van/Passenger Van)
#
Carefully place the spare wheel onto spare
wheel carrier 4 . The spare wheel is heavy.
When you place the spare wheel onto spare
wheel carrier 4 , the center of gravity
changes due to the weight of the wheel. The
spare wheel may slip down or tip over.
#
Slide the pump lever for the jack into sleeve
5 on spare wheel carrier 4 .
#
Raise spare wheel carrier 4 with the pump
lever and attach right-hand safety hook 3 .
#
Slightly raise spare wheel carrier 4 and
attach left-hand safety hook 3 .
#
Pull the pump lever out of sleeve 5 .
#
Using the lug wrench, tighten safety hook
bolts 3 by turning them clockwise.
#
Replace and engage covers 1 .
#
Close the rear-end doors.
228 Wheels and tires