Mercedes-Benz Sprinter 2019, Руководство по эксплуатации

Страница: 225 / 298

Raising the vehicle when changing a wheel
&
WARNING Risk of injury from jack tip‐
ping
If you park a vehicle with air suspension, the
air suspension may remain activated for up to
one hour, even when the ignition is switched
off. If you then raise the vehicle with the jack,
the air suspension will attempt to adjust the
vehicle level.
The jack may tip.
#
Press the Service button on the air sus‐
pension remote control before raising
the vehicle.
This prevents automatic readjustment
of the vehicle level and prevents it from
being raised or lowered manually.
&
WARNING Risk of injury from incorrect
positioning of the jack
If you do not position the jack correctly at the
appropriate jacking point of the vehicle, the
jack could tip with the vehicle raised.
#
Only position the jack at the appropriate
jacking point of the vehicle. The base of
the jack must be positioned vertically
under the jacking point of the vehicle.
&
WARNING Risk of injury from vehicle tip‐
ping
On slopes, the jack could tip with the vehicle
raised.
#
Never change a wheel on a slope.
#
Consult a qualified specialist workshop.
* NOTE Vehicle damage from the jack
If you do not position the jack correctly at the
appropriate jack support point of the vehicle,
the jack could tip over with the vehicle raised.
#
The jack is designed exclusively for
jacking up the vehicle at the jack sup‐
port points.
Requirements:
R
There are no persons in the vehicle.
R
The vehicle is prepared for changing a wheel
( → page 222).
Only position the jack on the jack support points
intended for this purpose. You could otherwise
damage the vehicle.
Important notes on using the jack:
R
Only use the vehicle-specific jack that has
been tested and approved by Mercedes-Benz
to raise the vehicle. If the jack is used incor‐
rectly, it could tip over while the vehicle is
raised.
R
The jack is designed only to raise the vehicle
for a short time while a wheel is being
changed and is not suitable for carrying out
maintenance work under the vehicle.
R
Avoid changing a wheel on uphill and downhill
slopes.
R
The jack must be placed on a firm, flat and
non-slip surface. If necessary, use a large,
flat, load bearing and non-slip underlay.
R
The base of the jack is positioned vertically
under the jacking point.
Safety instructions while the vehicle is raised:
R
Do not put your hands or feet under the vehi‐
cle.
R
Do not lie underneath the vehicle.
R
Do not start the engine and do not release
the parking brake.
R
Do not open or close any doors.
Vehicles with rear wheel drive
Jack support points
Only use the middle rod and the pump lever rod
with the largest diameter for the jack as a lug
wrench extension. Only insert the middle rod on
the lug wrench, and always as far as it will go.
Wheels and tires 223