X
Affix part
:
of the TIREFIT sticker to the
instrument cluster within the driver's field of
vision.
X
Affix part
;
of the TIREFIT sticker near the
valve on the wheel with the defective tire.
X
Pull connector
?
with cable and hose
A
out
of the tire inflation compressor housing.
X
Screw hose
A
onto flange
B
of tire sealant
bottle
:
.
X
Place tire sealant bottle
:
head downwards
into recess
;
of the tire inflation compres-
sor.
X
Remove the cap from valve
C
on the faulty
tire.
X
Screw filler hose
D
onto valve
C
.
X
Insert plug
?
into cigarette lighter socket
(
Y
page 294) or into another 12 V socket of
the vehicle (
Y
page 296).
X
Turn the SmartKey to position 1 in the ignition
lock (
Y
page 145).
X
Press on and off switch
=
on the tire inflation
compressor to position I.
The tire inflation compressor is switched on.
The tire is inflated.
First, tire sealant is pumped into the tire. The
pressure can briefly rise to approximately
500 kPa (5 bar/73 psi).
Do not switch off the tire inflation com-
pressor during this phase.
X
Let the tire inflation compressor run for a
maximum of five minutes. The tire should then
have attained a pressure of at least 180 kPa
(1.8 bar/26 psi).
If a pressure of 180 kPa (1.8 bar/26 psi) has
been attained after five minutes, see "Tire pres-
sure reached" (
Y
page 331).
If a tire pressure of 180 kPa (1.8 bar/26 psi) has
not been attained after five minutes, see "Tire
pressure not reached" (
Y
page 330).
If tire sealant has escaped, clean it off affected
areas as quickly as possible. Use plain water if
possible.
If your clothes are soiled with tire sealant, have
them cleaned with perchloroethylene at a dry
cleaner as soon as possible.
Tire pressure not reached
If a pressure of 180 kPa (1.8 bar/26 psi) has not
been attained after five minutes:
X
Switch off the tire inflation compressor.
X
Unscrew the filler hose from the valve of the
faulty tire.
Tire sealant may escape when the filler hose is
unscrewed.
X
Very slowly drive forwards or reverse approx-
imately 30 ft (10 m).
X
Pump up the tire again.
After a maximum of five minutes the tire pres-
sure must be at least 180 kPa (1.8 bar/
26 psi).
G
WARNING
If the required tire pressure is not reached
after the specified time, the tire is too badly
damaged. The tire sealant cannot repair the
330
Flat tire
Bre
ak
do
w
n
as
si
stan
ce
