Mercedes-Benz Freightliner Sprinter 2022, Руководство по эксплуатации

Страница: 215 / 334

#
Slowly turn coolant expansion reservoir cap
1 half a turn counter-clockwise and allow
excess pressure to escape.
#
Turn coolant expansion reservoir cap 1 fur-
ther and remove it.
#
Check the coolant level.
There is enough coolant in coolant expansion
reservoir if the coolant reaches the MAX mark.
AAdding coolant dding coolant
#
Re ll the coolant to the MAX mark on the cool-
ant expansion reservoir.
Only use coolant approved by Freightliner Sprinter
to avoid damaging the engine cooling system.
#
Replace coolant expansion reservoir cap 1
and tighten in a clockwise direction.
#
Start the engine.
#
A er approximately ve minutes, switch o the
engine again and allow it to cool down.
#
Check the coolant level again and add coolant
if necessary.
%
Observe additional coolant information
(
/
page 275).
FFilling up t illing up the windshield w he windshield washer syst asher system em
&
W WARNING ARNING Risk of burns from hot compo-
nent parts in the engine compartment
Certain components in the engine compart-
ment can be very hot, e.g. the engine, the radi-
ator and parts of the exhaust system.
#
Allow the engine to cool down and only
touch component parts described in the
following.
If you have to carry out any work in the engine
compartment, touch only the following compo-
nents:
R
Hood
R
Engine oil ller opening cap
R
Washer uid reservoir cap
R
Coolant expansion reservoir cap
&
W WARNING ARNING Danger of burns when opening
the hood
If you open the hood when the engine has
overheated or during a re in the engine com-
partment, you could come into contact with
hot gases or other escaping operating uids.
#
Before opening the hood, allow the
engine to cool down.
#
In the event of a re in the engine com-
partment, keep the hood closed and call
the re service.
&
W WARNING ARNING ‑ Risk of re and injury from
windshield washer concentrate
Windshield washer concentrate is highly am-
mable. It could ignite if it comes into contact
with hot engine component parts or the
exhaust system.
#
Make sure that no windshield washer
concentrate spills out next to the ller
opening.
* NNOOTE TE Damage to the exterior lighting due
to unsuitable windshield washer uid
Unsuitable windshield washer uid may dam-
age the plastic surface of the exterior lighting.
#
Only use windshield washer uids that
are also suitable for use on plastic surfa-
ces, e.g. MB SummerFit or MB WinterFit.
AAdding w dding washer asher uid uid
Washer uid reservoir (example)
#
Pre-mix the washer uid in the correct mixing
ratio in a container.
#
Park the vehicle on a level surface and secure
it against rolling away ( / page 134).
#
Open the hood ( / page 207).
#
Pull the cap of the washer uid container 1
upwards by the tab.
#
Pour in the pre-mixed washer uid.
Maintenance and care 213 213