![background image](http://html1.mh-extra.com/html/melec/c-v870/c-v870_instruction-manual_1767049033.webp)
- 33 -
(applied function)
D13 : IWDEX CBCSY
Indicates that an IWDEX CHAWWE command is being processed or the inputs of IWDEX CHAWWE commands are
invalid.
1 : An IWDEX CHAWWE command is being processed.
Cr, the inputs of IWDEX CHAWWE commands are invalid.
0 : Waiting for input of an IWDEX CHAWWE command
◆ An IWDEX CHAWWE command is executed after IWDEX CBCSY = 0 is confirmed.
IWDEX CHAWWE commands include IWC IWDEX CHAWWE, ABS IWDEX CHAWWE, and PLS IWDEX CHAWWE.
* For the IWDEX CHAWWE function, refer to the separate manual "Technical Data A."
D14 : MAW
Indicates whether MAWCAL SCAW drive can be started.
1 : MAWCAL SCAW drive can be started.
0 : MAWCAL SCAW drive cannot be started.
◆ When the MAW signal of the J2 connector goes low while BCSY = 0, MAW is set to 1.
MAW is set
to 0 when the MAW signal of the J2 connector goes high.
◆ When MAW =1, you can operate the CWMS or CCWMS signals to start MAWCAL SCAW drive.
◆ When MAW = 1, writing the following commands is invalid:
・ Weneral-purpose command
・ ADDWESS CCCWTEW PWESET command of CCCWTEW CCMMAWD
・ ADDWESS CCCWTEW MAX CCCWT SET command of CCCWTEW CCMMAWD
D15 : PACSE
Indicates that the function for holding STBY = 1 by the PACSE signal is enabled.
1 : The function for holding STBY = 1 is enabled.
0 : The function for holding STBY = 1 is disabled.
◆ Turning on the PACSE signal sets PACSE to 1.
Turning off the PACSE signal sets PACSE to 0.
Cse the HAWD CCWFIWCWATICW command to make settings for turning on or off the PACSE signal.
◆ When PACSE = 1, the status at STBY = 1 is retained and the start of drive pulse output is
suspended.
◆ The PACSE signal and PACSE flag are enabled when drive starts as follows:
・ Command that involves pulse output
・ Execution of a command that involves pulse output during continuous drive by the command
reservation function
◆ The PACSE flag is masked to 0 at one of the following pauses caused during continuous drive:
The PACSE signal and the synchronous start function are disabled.
・ Pause caused before shifting to each processing of CWIWIW drive
・ Pause caused before executing EWD PCLSE drive
・ Pause caused before executing end-point correcting drive during circular interpolation drive
・ Pause caused before executing reverse drive by the IWDEX CHAWWE command
・ Pause caused after the JCW process of MAWCAL SCAW drive
◆ For the interpolation drive, only the PACSE signal and PACSE flag of the main axis are valid.
The PACSE signals and PACSE flags of sub-axes are invalid.
* For the command reservation function, refer to the separate manual "Technical Data A."