Melco EMT 10/4, Инструкция по установке, эксплуатации и обслуживанию

Страница: 85 / 130

11817 Rev. A 4. Operator Maintenance
Lubrication 4-9
7. When trimmer picker
base shaft, rod pivot
displays, press .
No motion is required to
lubricate the trimmer pick-
er base shaft and rod
pivot. Refer to Figure 4-17
to lubricate the trimmer
picker base shaft and rod
pivot. Press
when
done. The picker will cycle
in and out.
If your peripheral is not equipped with trimmers, you do not have to
perform steps 5, 6, or 7. This completes the 80 hour maintenance.
You must perform ALL operations to clear the message.
480hr maintenance due
When this message appears, go into the 480 hour lubrication
menu , then press . When x axis dis-
plays, press . This causes the x
beam to move to the correct position for oiling.
Before you can oil the x-carriage, you must remove
the aluminum cover; there are 6 screws along the
top of the cover. Remove all 6 screws, then carefully
lift the cover off the x-carriage.
The x-carriage is a metal beam with a groove along
the front and back (along the top edge). When you
oil the x-carriage,
make sure you put one drop
of oil in the groove on each side of the metal
beam
. Figure 4-18 shows the groove along the
front of the x-carriage; there is another groove on
the back side of this beam.
Refer to Figure 4-19 to lubricate the x-carriage on
an EMT 10T.
Refer to Figure 4-20 to lubricate the x-carriage on
an EMT 10/4 or 10/4T.
Replace the cover on the x-carriage; be careful not
to over-tighten the screws.
Press when done. The x-carriage will move
back and forth to distribute the oil.
Figure 4-17
Put 1 drop
of oil here
(rod pivot)
Put 1 drop of
oil in this hole
(picker base
shaft)
▲
▲
Figure 4-19
▲
▲
▲
Oil at each
location
Figure 4-20
Oil at each loca-
tion; repeat for the other
side of the beam
Figure 4-18