Operating Instructions Tray washing machine Modell BTA 160 / 240
Datei:BA_BTA_9668415_EN_2009-10.docx
9668415
18/48
W e reserv e the right to c hange ex ec ution and constr uction!
MEIKO Maschinenbau GmbH & Co. KG, Englerstraße 3, D-77652 Offenburg, Tel.: +49/781/203-0, Fax: +49/781/203-1121
When the appliance is finally positioned, you must ensure that all the cleats carry
approximately the same weight.
An uneven distribution of weight can cause individual cleats to break.
You can check the loading by means of the force needed to turn the cleats with a
spanner.
An open-ended 27 mm
spanner is needed to
adjust the cleats of the
appliance!
Important:
Horizontal adjustment of the machine by means of the vertically adjustable
feet (spanner/wrench size 27) must be done with care to ensure that the
weight of the machine is evenly distributed on the cleats. This is absolutely
essential in order to avoid displacement or stresses caused by loading on
one side. These stresses can cause, for example, the vertical doors to jam
or can prevent them from being water-tight when closed.
•
Please also read the chapter on “General safety instructions ".
7.3
Installation and assembly
MEIKO has prepared an assembly diagram showing the machine dimensions and the
connected loads in detail.
Assembly is completed by reference to the assembly diagram and, in general, by
following the instructions of a trained MEIKO engineer.
The installation must
only
be connected by suitably qualified personnel.
We accept no liability for connections carried out by unqualified personnel.
After unpacking, position the appliance as indicated in the assembly diagram and as the
dimensions allow.
The appliance must be level and straight when erected.
7.4
Floor load from the dish-washing machine
The floor load per foot (with a loaded surface of D=30 mm per foot) is approximately 150
kg
7.5
Instructions for the disposal of the packaging material
•
The four-sided wooden frame consists of untreated, raw pine / spruce.
•
The plastic sheeting (PE sheeting) may be recycled.
•
The cardboard packaging material used to protect the edges can also be recycled.
•
The steel tensioning strap made of strip steel may be recycled with the steel scrap.
•
The plastic tensioning strap of plastic (PP) can be recycled.
IMPORTANT!
Содержание BTA160
Страница 48: ......