Megger TDS40, Руководство по эксплуатации, Страница: 9 / 71

1-9
1. GENERAL INTRODUCTION
The test and diagnosis system TDS40/60 shall be used for the stated field of application
in cable diagnosis and cable testing only. Any other application is strictly forbidden!
Megger cannot be made liable for any damage to persons or matter caused by using the
system for some other application.
This is why we advise you to absolutely abide by the safety precautions given in chapter1
whenever you use the TDS40/60.
Each person involved in the assembly, operation, maintenance, and repair of the
TDS40/60 is required to have read this handbook carefully.
Only trained and/or instructed staff are permitted to deal with the TDS40/60 and its
periphery. Other persons have to stay away.
This handbook must be available to the supervising, operating, and maintenance staff for
reference.
Never use foreign components on the TDS40/60 and its periphery, otherwise the safety
of the system is jeopardised.
The user is obliged to immediately report any occurring change in the system to the
supervisor in charge.
The operator is obliged to immediately shut down the system should any fault occur that
might pose a threat to the staff. The system is permitted to be switched on again only
after the fault has been eliminated.
The TDS40/60 and all its supplementary equipment has to be connected and operated
according to instructions. All relevant standards (DIN, VDE) shall be met. Any repair or
maintenance operation may be carried out only after all circuits have been shut down
(are in a dead state) and only by an electrical expert. A person is regarded an electrical
expert if due to his or her practical training, knowledge, and experience as well as
knowledge of the relevant standards he or she is able to assess the operation to be
carried out and detect every possible risk.
Attention!
The test and diagnosis system TDS40/60 is an upright device and has to be only
transported and operated in upright position.