Megger TDS40, Руководство по эксплуатации, Страница: 48 / 71

6-48
6.4.2 Parametrising the SystemCard
Using a SystemCard appropriately parametrized under WinkisVLF will enable you to make
volatile (only for the cable test under way) or permanent changes to your device settings.
Depending on how the card has been parametrized, either all or only certain test
parameters are affected.
That way, cable tests can be planned and prepared in the office using WinkisVLF. Later,
on site, you only have to plug the SystemCard into the system in order to change the
system settings the way it has been planned.
Furthermore, this will allow you to prepare volatile print templates (individual header lines
and footer lines for the ongoing cable test) or non-volatile print templates (as default
protocol template for permanent use) (see section 6.3).
By defining “print time points” using WinkisVLF you can also schedule the logging timeline.
These “print time points” are only valid for the cable test under way and cannot be stored
permanently.
For detailed information about the WinkisVLF software, please refer to its online help.
The parameters stored on a SystemCard are automatically adopted by the test and
diagnosis system right after the card has been plugged into the respective slot on the
control unit (see section 6.4.4).