16. Select the new Motor ID you just created then open the
Tests
tab. The Motor ID and Test ID should be selected,
similarly to the example shown below.
17. Ensure that the proper Test ID appears in the
Test ID
field.
Fig 34:
Selecting single coil testing Motor ID and Test ID.
18. Check the
Edit Test ID
box then enter the current password when requested.
19. If you will be running other tests (such as resistance test, a common application in coil testing) ensure that the
parameters enabling single-phase testing have been set up in the
Temperature/Resistance Test
setup window as
described earlier in this chapter, but leave the tests set to
OFF
while completing the Test ID setup process.
20. After returning to the
Tests
tab, click on the
Surge Test ON/OFF
button to activate the test.
21. Click on the
Run Auto Test (PTT)
button. The
Surge Test
window should open.
Fig 35:
Setting Surge parameters; preparing to acquire a test reference.
22. Set your test parameters as needed (Surge Voltage according to device needs, others similar to the example
shown above).
Using Power Packs with Baker AWA Testers
38
Baker Power Packs User Guide 71-061RC EN V2
www.megger.com
Содержание PPX30
