Megger MTO210, Инструкция по эксплуатации

Страница: 16 / 74

M
AVTMMTO210 Rev 7 Sept 2013
8
General Safety Precautions
The MTO and the Unit Under Test (UUT) should both be considered as sources
of instantaneously lethal levels of electrical energy. Observe the following safety
precautions:

Observe all safety warnings on the equipment. They identify areas of
immediate hazard that could result in injury or death.
 Use this equipment only for the purposes described in this manual. Observe
strictly the Warning and Caution information provided in this manual.
 Treat all terminals of high-voltage power equipment systems as potential
electric shock hazards. Use all practical safety precautions to prevent contact
with energized parts of the equipment and related circuits.

Use suitable barriers, barricades and/or warnings to keep persons not directly
involved with the work away from test activities.

Never connect the test equipment to energized equipment.

Do not use in an explosive atmosphere.

Use the grounding and connection procedures recommended in this manual.
Always disconnect test leads from power equipment before attempting to
disconnect them at the test set. The ground connection MUST be the first
made and removed last. Any interruption of the grounding connection can
create an electrical shock hazard.

Personnel higher than 5 feet should follow proper tie off safety requirements.

Personnel should use proper safety gear to prevent bodily harm.

Personnel using heart pacemakers should obtain expert advice on the
possible risks before operating this equipment or being close to the
equipment during operation.

Fuse selection is dependent on input voltage. 230VAC uses 3.15 amp fuses
and 120VAC uses 6.3 amp fuses.
F
WARNING
No user serviceable parts inside! Refer all
servicing to the factory or a qualified authorized
service company!