Megger MTO210, Инструкция по эксплуатации

Страница: 14 / 74

M
AVTMMTO210 Rev 7 Sept 2013
6
IDLE STATE - When pushed the unit will start a test
on a transformer. This will only occur if the
instrument is in Test Mode (see Function Mode
Switch above).
The TEST INDICATOR above the button will
illuminate during the test.
TEST STATE – When pushed the unit will stop a
test on a transformer, maintain the results on the
screen. It will save and/or print the results
dependent on the Data Output Mode Switch.
When pushed will stop testing and discharge the
transformer. The DISCHARGE INDICATOR to the
left will illuminate during the discharge cycle.
When pushed will perform a transformer
demagnetization. The DEMAG INDICATOR to the
right will illuminate during the demagnetization
cycle.
When pushed, the unit will acknowledge data entry,
displayed messages and during test mode, save
data presented on the display.
Symbol highlights that the button will PRINT
the test results out the RS232 port when pushed
and in Storage Review Mode.
In ready mode, button will change the
sensitivity of the current transition detection
sensitivity. Off is default.
Symbol highlights that the button will give the
user the ability to DELETE the last recorded test in
memory. If pressed a second time, the unit will give
the user the ability to delete all tests in memory. If
pressed a third time the unit will no longer be in the
delete function.
In ready mode, button turn toggle ON/OFF the
OHM2 display.