Medivance Arctic Sun Stat, Руководство по обслуживанию

Страница: 65 / 67

62
Service Manual
Appendix I - Transmission Interface Module Data Output Format
The data output stream is a repeating sequence of ASCII characters every five seconds. A “$” is sent as the first item of a new
data sequence. Each data item within the sequence is separated by a comma (ASCII 44). The data sequence is terminated with
a carriage return character (ASCII 13) followed by a new line character (ASCII 10). The time since the power up of each data
sequence can be calculated from the serial sequence number and communications output interval.
Example: $,13,36.5,36.4,34.5,2,0,14.3,14.4,16.5,4.6,14.2,0,60,0,2.3,5,-7.1,0,45,165,1,4.00
Output Data Parameters are listed in the table below.
Transmission Interface Module - Data Output Parameters
Sequence No. Description Values
1 Sequence Start Indicator $ (ASCII 36)
2 Serial Sequence Number 1,2,3,4,5…., Initialized at power up
3 Patient Temperature 1 °C, 0 if probe not connected
4 Patient Temperature 2 °C, 0 if probe not connected
5 Patient Target Temperature in Auto Mode °C, regardless of current mode
6 Operating Mode 0=Initialization, 1=Stop, 2=Automatic,
3=Manual, 4=Purge, 5=Fill, 6=Monitor
Mode
7 Diagnostic Mode 0=Normal Mode, 1=Diagnostic Mode
8 Outlet Water Temperature Monitor °C
9 Outlet Water Temperature °C
10 Inlet Water Temperature °C
11 Chiller Water Temperature °C
12 Water Outlet Target Temperature °C
13 Temperature Display Mode 0=°C, 1=°F
14 Communications Output Interval Seconds
15 Current Alarm Number See Alarm/Alert list for corresponding
numbers
16 Flow Rate Liters/minute
17 Reservoir Level Last Measured 5 or 4=Full, 3=3/4, 2=1/2, 1=Low, 0=Empty
18 Inlet Pressure Pounds per square inch
19 Heater Power 0-32 where 32 =100%
20 Mixing Pump Power 0-200 where 200 = 100%
21 Flow Pump Power 0-235 where 235 = 100%
22 Control Parameter Mode 1,2,3
23 Software Version Software Version