Medivance Arctic Sun Stat, Руководство по обслуживанию

Страница: 39 / 67

36
8.5 Replace Front Case Assembly Components
Service Manual
Fig 8-13 Disconnect communications/power connectors (step 6)
Fig 8-10 Back Panel with removal of screen filter and screws
Tools and Supplies required:
• 7/16” (11mm) nut driver
• Flat blade screwdriver
1.
Lock all casters prior to attempting to remove the
front case assembly.
2.
Disconnect the ethernet cable, USB cable and T.I.M.
cable from the control panel.
3.
Using a 7/16” (11mm) nut driver, remove the four
(4) screws that hold the front case assembly to the
frame.
4.
If necessary, use a flathead screwdriver to gently
pry the front case assembly from the frame. Take
care not to damage shell if using a tool to pry shell
from frame.
5.
Slide the front case assembly forward and rest on
the ground. Remove the ferrite from the bracket on
the back of the card cage.
6.
Remove the zip tie around the communications
connector and disconnect both communications
and power connections from the top of the card
cage.
Fig 8-11 Disconnect cables from control panel (step 2)
Fig 8-12 Remove screws from Front Case Assembly (step 3)
Tools and Supplies required:
• 7/16” (11mm) nut driver
1. Place the front case assembly on its side to allow
for easier access to the control panel assembly.
2. Disconnect the upper main harness and speaker
harness from the control panel.
3. Using a phillips screwdriver, remove the four (4)
screws securing the control panel bracket to the
control panel then remove the bracket assembly
with harnesses attached from the control panel.
4. Using a 7/16” (11mm) nut driver, remove the two
(2) screws securing the control panel strap then
remove the control panel and strap from the front
panel.
5. Using a 7/16” (11mm) nut driver, remove the two
(2) screws on each side securing the handle support
plates to the left and right side panels then remove
the support plates.
8.4 Remove Front Case Assembly