Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 32 / 66

Chapter 3 - Powering on the Mediatrix 3300 RESET/DEFAULT Button
22 Mediatrix 3300 – Analog Gateway
LED Patterns – Default Behaviour
When no specific condition matches those described in Table 11 , the LEDs behave individually according to
the following rules:
RESET/DEFAULT Button
The RESET/DEFAULT button allows you to:

Cancel an action that was started.

Revert to known factory settings if the Mediatrix 3300 refuses to work properly for any reason
or the connection to the network is lost.

Reconfigure a unit.
At Run-Time
The RESET/DEFAULT button can be used at run-time – you can press the button while the Mediatrix 3300 is
running without powering the unit off. Table 13 describes the actions you can perform in this case.
Table 12: Default LED Behaviour
LED Type
a
a. The ERROR/ALARM and ERROR/TROUBLE indicators do not currently have individual
behaviours like the other indicators.
Condition Behaviour
Power
RestartInProgress Blinking green, 1 Hz, 50% duty
RestartCompleted Steady green
Ethernet
No network traffic, 100 Mbits/s Steady green
No network traffic, 10 Mbits/s Steady orange
Network traffic, 100 Mbits/s Blinking green, variable rate
Network traffic, 10 Mbits/s Blinking orange, variable rate
In Use
Lines Idle and Unlocked Off
Lines InUse and Unlocked Steady green
Shutting Down Steady yellow
Locked Blinking yellow, 1 Hz, 50% duty
Table 13: RESET/DEFAULT Button Interaction
RESET/
DEFAULT Button
Pressed for:
Action Comments LEDs Pattern
2 to 6 seconds Restarts the
Mediatrix 3300 No changes are made to the
Mediatrix 3300 settings. Power LEDs:
• blinking green,
1Hz, 50% duty
All other LEDs:
• OFF
7 to 11 seconds Sets the Mediatrix
3300 in Partial Reset
Mode Sets some of the Mediatrix 3300
configuration to pre-determined
values. All LEDs
• blinking, 1Hz,
50% duty