Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 30 / 66

Chapter 3 - Powering on the Mediatrix 3300 Indicators (LEDs)
20 Mediatrix 3300 – Analog Gateway
Vocal Unit Information
When entering special characters on your telephone pad, the Mediatrix 3300 talks back to you with relevant
information.

To access vocal unit information:
1. Take one of the telephones connected to the Mediatrix 3300.
2. Dial one of the digits sequence on the keypad.
Verifying the Installation
There are a few ways to verify that the Mediatrix 3300 is properly connected to the IP network and is working:

By contacting it with a SNMP browser

By contacting it via the CLI

By contacting it via a web browser

By pinging it
These procedures assume that you know the IP address of the Mediatrix 3300 you want to verify. If the
Mediatrix 3300 does not respond, do the following:

Verify that the LAN and WAN cables are securely connected to the Mediatrix 3300 and to the
network connectors.

Be sure that you did not connect crossover network cables.

Verify the state of the IP network to ensure it is not down (the ETH LED should be ON or
blinking).
Indicators (LEDs)
The indicators (LEDs) of the Mediatrix 3300 are described in “Mediatrix 3300 Connectors and Indicators” on
page 2 .
LED Patterns – Specific Conditions
Table 11 describes the different states a Mediatrix unit can have and their associated LED patterns.
Table 10: Vocal Unit Information
Digits to Dial Information Vocally Sent by the Mediatrix 3300
*#*0 Current IP address of the Mediatrix 3300 (static or DHCP).
*#*1 MAC address of the Mediatrix 3300.
Table 11: LED Patterns
Condition Description LED Pattern
RestartPending Triggered when the RESET/DEFAULT button is
pressed in the ResetPending state. The unit
prepares for a physical shutdown and restart.
Power LEDs:
• blinking green, 1Hz,
50% duty
All other LEDs:
• OFF
RecoveryPending Triggered when the RESET/DEFAULT button is
pressed at start-time or for at least 7 seconds.
All LEDs:
• blinking, 1Hz, 50%
duty