Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 24 / 66

Chapter 2 - Installation Hardware Installation
14 Mediatrix 3300 – Analog Gateway
Hardware Installation
This section describes how to set the connectors of the Mediatrix 3300.
See “Appendix B - Cabling Considerations” on page 35 for more details on the cables the Mediatrix 3300 uses.
Connecting Cables
The following describes how to connect the various cables to the Mediatrix 3300.
Figure 12: Hardware Installation

To install the cables:
1. Before you begin, be sure that the Mediatrix 3300 is powered off.
2. Create a WAN connection by connecting a 10/100 BaseT Ethernet RJ-45 cable into the ETH5
connector of the Mediatrix 3300. Connect the other end to the cable or DSL modem.
See “RJ-45 Cable” on page 35 for more details on this cable.
3. Create LAN connections by connecting 10/100 BaseT Ethernet RJ-45 cables into the ETH1 , ETH2 ,
ETH3 , and ETH4 connectors of the Mediatrix 3300. Connect the other end to a compatible Ethernet
interface that supplies TCP/IP network access (e.g., router, switch, hub or computer).
See “RJ-45 Cable” on page 35 for more details on this cable.
4. Connect a SCN line into the FXO connector of Slot 2/3 sections of the Mediatrix 3300 (optional).
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
5. Connect analog telephones or fax machines into the FXS connectors of the Slot 2/3 sections.
Use a standard telecommunication cord with a minimum of 26 AWG wire size.
Warning:
Do not connect the Mediatrix 3300 directly to Telecommunication Systems.
Caution:
The Mediatrix 3300 must be installed on a circuit equipped with a breaker so that you can easily
power the unit off if required.
Warning:
To avoid electrical shock, apply the following instructions:
•
The device must be installed by technical personnel.
•
Be sure the ground path is connected.
•
Disconnect the SCN interface connectors before disconnecting the power cord from the device.
Slot 3
Slot 2
Slot 1
Basic Slot
2
3
4
4
5
5
7
8
Note:
The Mediatrix 3300 telephone line interface has been designed to interface with a conventional
telephone or fax machine. Connections to FXS ports of third party devices such as a PBX / Key System
could damage the Mediatrix 3300.