Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 22 / 66

Chapter 2 - Installation Location and Mounting Requirements
12 Mediatrix 3300 – Analog Gateway
The following guidelines are provided to ensure your safety:
• Mount the Mediatrix 3300 at the bottom of the rack if it is the only unit in the rack.
• When mounting the Mediatrix 3300 in a partially filled rack, load the rack from the
bottom to the top with the heaviest component at the bottom of the rack.
• If the rack is provided with stabilizing devices, install the stabilizers before mounting or
servicing the Mediatrix 3300 in the rack.
8. Proceed to “Hardware Installation” on page 14 .
Wall-Mounting
You can use the mounting brackets to wall-mount a single Mediatrix 3300.

To wall-mount the Mediatrix 3300:
1. Disconnect all of the cables from the Mediatrix 3300 before mounting, if applicable.
2. Ensure that the wall you are using is smooth, flat, dry and sturdy. Attach a piece of plywood,
approximately 305 mm x 510 mm x 12 mm (12 inches x 20 inches x 0.5 inches) securely to the wall,
if necessary.
3. Place the Mediatrix 3300 right side up on a hard flat surface, with the front facing toward you.
4. Place one bracket over the mounting holes on the left side of the Mediatrix 3300 and align the
bracket with the screw holes and tab hole as illustrated in
Figure 10 .
Figure 10: Wall-Mounting Installation
Table 8 describes the mounting pieces you need to wall-mount the Mediatrix 3300.
5. Insert the two screws in the mounting bracket, and then tighten.
Caution:
You can wall-mount the Mediatrix 3300 with either the right or left side facing up; however, the
front and rear panels must be vertical.
Table 9: Wall-Mounting Pieces
Item Qty. Description
A 1 Mediatrix 3300 casing
B 2 Bracket
C 8 18-8 SS Flat Head Philips Machine Screw 8-32 Thread, 5/16" Length
A
C
B
Note:
Use the screws supplied with the mounting brackets. Damage caused to the unit by using incorrect
screws invalidates your warranty.