Media5 Mediatrix 3308, Руководство по установке оборудования

Страница: 21 / 66

Location and Mounting Requirements Hardware Installation Guide
Mediatrix 3300 – Analog Gateway 11
Rack-Mounting
The Mediatrix 3300 fits in most standard 48.26 cm (19 in.) racks. Media5 recommends to use a rack compliant
EIA-310-D.
All LEDs located on the front panel are also duplicated on the rear of the Mediatrix 3300, which allows you to
rack-mount the unit with the front or the rear facing forwards.

To rack-mount the Mediatrix 3300:
1. Disconnect all of the cables from the Mediatrix 3300, if applicable.
2. Place the Mediatrix 3300 right side up on a hard flat surface, with the front or rear facing toward you
according to the way you want to insert it in the rack.
3. Place one bracket over the mounting holes on the left side of the Mediatrix 3300.
• For a front facing installation, place the bracket at the front of the unit.
• For a rear facing installation, place the bracket at the rear of the unit, inverted.
4. Align the bracket with the screw holes and tab hole as illustrated in Figure 9 .
Figure 9: Rack-Mounting Installation
Table 8 describes the mounting pieces you need to rack-mount the Mediatrix 3300.
5. Insert the two screws in the mounting bracket, and then tighten.
6. Repeat steps 3, 4 and 5 for the other side of the Mediatrix 3300.
7. Insert the Mediatrix 3300 into the rack and secure with suitable screws (not provided). Be sure that
the fan is not obstructed.
To prevent bodily injury when mounting or servicing the Mediatrix 3300 in a rack, ensure that the
rack remains stable.
Standards Supported • EIA-310-D
• ETS 300 119
Table 8: Mounting Pieces
Item Qty. Description
A 1 Mediatrix 3300 casing
B 2 Bracket
C 4 18-8 SS Flat Head Philips Machine Screw 8-32 Thread, 5/16" Length
A
B
C
Front Facing Installation Rear Facing Installation
Note:
Use the screws supplied with the mounting brackets. Damage caused to the unit by using incorrect
screws invalidates your warranty.