mecalac AF 1050, Руководство по эксплуатации

Страница: 83 / 148

F1050/F1200 8-15
Maintenance 8
Figure 8-32
(7) Install the air filter lid on the filter housing in such a way
that the direction arrow in the marking „
OBEN-TOP “
roughly points to half past one.
N O T E
The dust removal valve must be checked from
time to time and cleaned if necessary.
CAUTION
Check all connection pipes and hoses of the air
filter system for damage before starting the
engine.
8.2.11 Replacing the safety cartridge
CAUTION
- The safety cartridge must not be cleaned.
- The safety cartridge must be replaced after
the filter cartridge has been maintained/
cleaned 5 times, but no later than after two
years.
- Make sure that no dirt or dust can enter the
filter housing during replacement of the safety
cartridge.
(1) Remove the filter cartridge (section 8.2.10).
(2) Pierce the seal of the safety cartridge (8-32/arrow)
from the inside by using a screwdriver or similar tool and
pull up both strips.
(3) Hold the safety cartridge by both strips and pull it out
by carefully turning it back and forth. Replace the safety
cartridge and the filter cartridge by new ones.
(4) The remaining assembly is performed as described in
section 8.2.10 (6) and (7).
8.2.12 Replacing the starter battery
NOTE
The starter battery is a maintenance-free part
according to DIN 72311, section 7. It is located
to the right in the motor compartment.
(1) Open the motor hood.
(2) Remove the main battery switch (8-34/arrow).
(3) Loosen and remove the fastening screw (size 17)
(8-33/arrow) of the battery holder.
(4) Loosen and remove the battery clamps (size 13).
DANGER
Always remove the negative terminal first and
then the positive terminal. Installation is in
reverse order.
Figure 8-33
Figure 8-34