mecalac AF 1050, Руководство по эксплуатации

Страница: 65 / 148

AF1050/AF1200 7-5
Rescue, towing, lashing, 7
lifting by crane
7.1.1.2 Towing the front loader if the propul-
sion drive has failed
(1) Actuate the toggle switch for the hazard flasher (4-9/4).
(2) Apply the parking brake (4-12/2).
CAUTION
If the rescue location is on a slope, wheel chocks
must be placed on the sloping side of both front
axle wheels in addition to applying the parking
brake.
(3) Set the drive switch (4-11/4) to “0”.
NOTE
The preparations described in steps (5), (6)
and (8) are only to be carried out if the rescue
location is
not on a public road:
(4) Switch the switching lever for the steering to the „rear-
wheel steering“ position (chapter 5.5).
(5) Cover the bucket cutting edge and teeth with the
bucket protector (5-4/arrow).
(6) Insert the plug of the bucket protector into the socket
(5-5/arrow, option).
(7) Lift and mechanically prop up the bucket arm [e.g. by
inserting the bucket arm support (option) (1-1/arrow)] and
lower the bucket arm until it rests on the bucket arm support.
(8) Set the toggle switch for switching off pilot control
(4-10/2) to
„up“ .
(9) Connect the tow rod to the loader to be towed (7-2/
arrow) and to the towing vehicle.
CAUTION
The loader does not have a shunting and towing
coupling at the front and for this reason may
only be towed rearwards.
(10) Switch the hydrostatic drive motor to free oil flow
before towing. To do so, turn out the two-way valve
(7-3/1) with an Allen key (size 8) all the way to the left
(7-3/2).
NOTE
- Turn the two-way valve (7-3/1) back in when
towing is finished.
- The traction drive is located in the engine
compartment on the left side.
(11) Remove the chocks (if applicable).