MDS LEDR 1400F, Руководство по установке и эксплуатации

Страница: 36 / 154

28 LEDR Series I/O Guide MDS 05-3627A01, Rev. D
using the
user
command. See Page 86 for complete description of
user
command.
NOTE:
It is recommended that users log out when finished using the
front panel navigation keys or console terminal. This can be
done using the
Logout
screen on the radio, or the
logout
command from a console terminal as appropriate. If there is no
key or terminal activity for 10 minutes, the radio automatically
logs out and reverts to read-only status.
4.6 STEP 5—Review Essential Operating
Parameters
Review and set the following parameters to allow data throughput and
interconnection with the network. These are radio operating frequen-
cies, data interface clocking, and data framing.
Table 12 outlines these
based on each model group and configuration.
Table 12. Essential Parameters for Standalone & Protected
Model
Group Data
Interface Parameter Setting
Subrate EIA-530 RF TX/RX
Frequency Factory configured for customer
frequencies.
Clocking
Use clkmode command (
Page 55
)
to match interface equipment.
Framing Does not apply.
FT1/FE1 RF TX/RX
Frequency Factory configured for customer
frequencies.
Clocking Automatically set to match
connected equipment.
Framing Set as appropriate using fstruct
command (
Page 59
).
Time Slot Set as appropriate using timeslot
command (
Page 84
).
Line Code Set as appropriate using linecode
command (
Page 66
).
Fullrate E1 RF TX/RX
Frequency Factory configured for customer
frequencies.
Clocking No settings are necessary. Radio
automatically detects clock and sets
mode.
Framing • Radio set to unframed (default).
• Make changes as appropriate
using fstruct command
(
Page 59
) to match interface
equipment.
Line Code Set as appropriate using linecode
command (
Page 66
).