MCZ Vivo 85 Hydro, Руководство по установке

Страница: 65 / 76

1
2
3 4
1
63
10-CLEANING AND MAINTENANCE
Technical Dept. - All rights reserved - Reproduction is prohibited
PERIODIC CLEANING PERFORMED BY A QUALIFIED TECHNICIAN
CLEANING THE SMOKE DUCT AND FITTING
To clean and maintain the smoke fan (1) you need to pull the product out of its housing. The fan is located in the middle, under the firebox.
Clearly, the smoke evacuation fan must be removed to perform these maintenance operations.
The smoke fan is coupled to the flue connection by a pipe (4). There is a gasket (3) on the end of this pipe (the end towards the flue
connection) to maintain a tight seal with the smoke fitting (2). Always ensure this gasket is intact and if necessary, replace it. The gasket
can also be adjusted via a screw. The pressure on the fitting can be increased or decreased by loosening the screw.
The flue connection is housed, with its ash collection compartment (1), on the rear/side of the product, where the smoke outlet pipe is.
Also clean this compartment with a vacuum cleaner by inserting the nozzle on the pipe inlet hole.
Then clean the smoke exhaust system, especially around the fittings, curves and any horizontal sections. For information on cleaning the
flue, contact a chimney sweeper.
ATTENTION: the frequency of cleaning the smoke exhaust system depends on product use and the type of installation.
OTHER CHECKS
All gaskets fitted on components subject to maintenance (smoke extraction fan, inspection panels, etc...) must be replaced when these
parts are taken down for maintenance. Verify the tightness of the gaskets on the firebox door and if necessary, contact an authorized
service centre for them to be replaced.
The company recommends relying on an authorised service centre for end-of-season cleaning and maintenance, as they will carry out all
of the previously mentioned work and also a general check of the components.