MCZ Vivo 85 Hydro, Руководство по установке

Страница: 59 / 76

57
8-SAFETY DEVICES AND ALARMS
Technical Dept. - All rights reserved - Reproduction is prohibited
A09
The smoke probe is faulty and does not detect
the exhaust smoke temperature properly.
Contact an authorised service centre to have the
component replaced.
A10
The ignition plug is faulty. Contact an authorised service centre to have the
component replaced.
A11 Pellet supply fault. Contact an authorised service centre to have the
component replaced.
A14
Faulty air flow rate sensor. This alarm does not block the stove, just a warning is
displayed. Contact an authorised service centre to have
the component replaced.
A17
Water temperature too high due to:
• Stove running at maximum power, closed
radiators.
• The system is over-sized ex. small room,
high capacity product
This alarm does not block the stove, just a warning is
displayed.
Ensure that all of the radiators are open, if the alarm
continues, contact an authorised assistance centre.
A18
Water tank temperature too high. This alarm is triggered when the water in the system
does not circulate and the temperature increases as a
result.
Check and re-enable the pump if necessary. If
necessary, call the assistance centre to have the
component replaced.
SErvice
Routine maintenance alert. When this flashing message appears upon start-up
it indicates that the preset operating hours before
maintenance is due have elapsed and that a qualified
manufacturer technician must be contacted for
maintenance.
DELETING THE ALARM STATUS
If an alarm is triggered, hold-down the on/off key to reset normal product operation. If the cause that triggered he alarm does not persist,
after a brief verification, the product exits the alarm state and can be switched back on again.
NEVER open the stove door whilst it is either in the initial start-up or on its shut down cycle, pellets will still be
smoldering or therefore volatiles may be present.
CAUTION!
If during operation or initial ignition you encounter combustion smoke spillage in to the room from the appliance
or the flue then please switch off the appliance, ventilate the room and contact the installation / service technician
immediately.