MCZ Vivo 85 Hydro, Руководство по установке

Страница: 39 / 76

37
6-HYDRAULIC CONNECTION
Technical Dept. - All rights reserved - Reproduction is prohibited
WATER CHARACTERISTICS
The characteristics of the water used to fill the system are very important to prevent the build-up of mineral salts and the formation of
incrustations along the pipes, in the boiler and in the heat exchangers.
Therefore, please GET YOUR PLUMBER’S ADVICE CONCERNING:
• Hardness of water circulating in the system, to prevent problems of incrustation and limescale, especially in the
domestic water heat exchanger. (> 25° French).
• Installation of a water softener (if water hardness exceeds 25° French).
• Filling the system with treated water (demineralised).
• Possibly providing an anti-condensation circuit.
• Installation of plumbing bumpers to prevent the phenomenon known as “water hammer” from occurring
along the fittings and pipes.
For those who have very extensive systems (with large amounts of water) or which require frequent refilling, to install water softening
systems.
It should be remembered that incrustations drastically reduce performance due to low thermal conductivity.
EXAMPLE INSTALLATION DIAGRAMS
The following diagrams are to be used only as a guideline. For proper connection, always follow the notes of the
plumbing and heating installer. The plumbing system must meet local, regional, or national requirements in
force. Installation and verification of operation is to be performed only by specialised, authorised personnel. The
manufacturer will not be held liable for non-compliance with the provisions listed above.
KEY
M Pressure gauge BA Storage boiler
V Valve RA Radiators
A
Water hammer absorber
PR
Radiant panels
Flt System filter PS Solar panels
RP Pressure reduction valve R Tap
Add Softener V1 Thermostatic diverter valve
C
Methane gas boiler
B Storage cylinder