Pellet
27
7-LOADING THE PELLETS
Technical Dept. - All rights reserved - Reproduction is prohibited
It is extremely important to make sure the product is not immediately overheated and the temperature is increased gradually starting
from the low power.
This will prevent damaging the welds and the steel structure.
DO NOT EXPECT HEATING EFFICIENCY IMMEDIATELY!!!
LOADING THE PELLETS
Fuel is loaded from the front tray above the door. The loading procedure is facilitated if performed in a number of steps as described below:
• Open the tray with the supplied cold handle. The guides of the tray have an end-of-travel that block the mobile part when extracted
completely. The tray is blocked in place when fully extracted by lifting it slightly and pulling it towards you.
• Pour the pellets into the tray directly from the bag or using the supplied spade (A).
• Push the pellets towards the hopper using the supplied tool (B).
If loading pellets when the stove is running, open the door of the tank using the stove mitten that comes with the
stove itself.
When loading, do not let the pellet bag come into contact with hot surfaces.
Never remove the protection grid inside the hopper.
No other type of fuel other than pellets is to be inserted into the hopper, in compliance with above-mentioned
specifications. Store the spare fuel at an adequate safe distance.
Do not pour pellets directly onto the brazier but only into the hopper.
SPADE A
TOOL B
