38
6.2.4
Replacing the belt
If, following a visual inspection, it emerges that
the belt is worn or broken, replace it operating
as follows:
•
Wait for the engine to cool;
•
Remove the fixed segregation guard of
the belt by unscrewing the 2 hexagonal
head screws and the 2 washers (Fig.
6.4) by means of a T-wrench;
•
Replace the belt as shown like in FIG.
6.5, by turning the pulley and remove
the belt (fig. 6.5, b);
•
Fit the new belt by turning the pulley to
position it correctly;
•
Reassemble the fixed segregation
guard
of
the
belt
previously
disassembled.
6.2.5
Refill of engine oil
If necessary (if the visual check results in a
lack of oil), top off the lubricant.
The topping can be performed when the
machine is mounted and in upright position.
•
Remove the oil filler cap and
dipstick and clean (Fig. 6.6 a);
•
Reinsert the cap without screw and
remove it to check the oil level;
•
If the oil level is near or below the
minimum detectable on the dipstick,
refill with the oil recommended by the
manufacturer;
•
By means of a funnel-shaped carafe
insert the oil in the tank (c);
•
Insert the cap/dipstick and close it.
IMPORTANT!
Check the operator's manual for
more information about topping
off of the engine oil and the type of
oil to use.
Wait for the engine to cool before
performing the maneuver
FIG. 6.4
FIG. 6.5
a
b
FIG. 6.9
a
b
c
FIG. 6.6
a
b
c
Содержание 1741219-174999
