MBM FC-10, Руководство по обслуживанию

Страница: 29 / 45

28
2. Causing the upper-station paper to first come out (*)
When the system constant G is set to a
larger value than 180, the upper-station
paper will first come out. To feed paper to
an after processing machine such as booklet
maker in which a transfer roller/belt is
placed under the paper, use the above
setting.
1
3
2
4
1
2
3
4
* Note: For the right paper ejection, the same setting can be performed by the d value. The paper
stacked on the first-station shelf comes out first but is ejected to the bottom of an ejected
collation set on crisscross stacker.
3. Causing the lower-station paper to first come out (*)
When the system constant G is set to a
smaller value than 180, the lower-station
paper will first come out. For such an after
processing machine in which paper
alignment is performed by paper jumping as
a large-capacity stacker or a jogger, use this
setting.
However, note that when the system
constant G is set to 0, a paper feed cannot
be normally performed.
1
3
2
4
1
2
3
4
* Note: For the right paper ejection, the same setting can be performed by the d value. The paper
stacked on the bottom-station shelf comes out first but is ejected to the bottom of a collated set
on crisscross stacker.
Indication
Counter Contents of indication
Operation Remarks
1000 digit G －
100 digit
10 digit
1 digit
Paper feed interval for right
paper ejection
Ten-key
Note: How much does the ejected sheet-to-sheet distance shift if the system constant G is
incremented or decremented by 1?
The space of the paper feed table of the collator is a distance of 3.1
"
for each station. Aligning
paper ends delays a paper feed by 3.1
"
each for each station.
From calculation with the G value (160/180) at a paper feed with the paper ends aligned, the
following shift amount is caused by incrementing or decrementing the system constant G by 1.
For the 60 Hz region: 3.1
"
180 = 0.02
"