MBM FC-10, Руководство по обслуживанию

Страница: 8 / 45

7
2. PRECAUTION FOR MAINTENANCE AND INSPECTION
・
Before starting maintenance and inspection work, be sure to turn the power off and remove the power
cord from the outlet.
・
Photo sensors are used in various parts of this machine. Be sure to clean them when maintenance work
is conducted.
・ Thin wires are used for wiring in circuit boards. Be sure to grip the socket when setting or removing the
connector.
Also, when setting the connector, take care that wires are not stretched too tight and slack wires are not
in contact with the drive units and insert the socket into the end. Should the wires are in contact with
the drive units, it may cause a disconnection.
3. SETTING PAPER
3.1 Precautions for setting paper
(1) Use the fill line on the paper guide as the loading capacity. In case of printed paper, do not load too
much as it tends to swell.
(2) Fan out sheets well and then load them on the feed table. Failure to properly fan sheets may lead to
trouble.
[How to fan out sheets]
1) Pinch the sheets of paper at both ends.
2) Bend them to admit air.
(Loosen the force lightly and pinch them again after
bending)
3) Jog and align the sheets vertically.
(3) Align sheets at the edges and insert them until they lightly strike the forward guide. Failure to properly
align sheets may lead to double feed or no feed.
(4) Make sure any ink on the paper is dry. Let ink dry before loading paper. Wet ink soils the feed rollers
and the separator rubbers. It can lead to malfunction, such as double feed or no feed.
(5) Copied sheets may cause wrong feed or stacking error owing to electrostatic charge. Static electricity
can be controlled by spraying a retail static eliminator on the feed rollers and the front edge of the paper.
Too, since copied sheets are apt to curl at the edges; straighten or invert them before feed table loading.
(6) Be sure to load no-carbon-required paper (general quality) with the color developing side (usually the
print side) down, otherwise the side coated with color former will probably be marked with rubbed
traces when contacting the feed roller.
(7) Front and back sides of ejected paper change according to ejected direction (with independent use or
when connected). Be very careful when the collator is operated with after-processing equipment such
as the booklet maker.