MasterCraft 54-4790-6, Руководство пользователя

Страница: 32 / 39

32
CUTTING WOOD
– cont’d
WARNING:
Once the cutting
operation is complete, verify that the saw
blade has come to a complete stop before
setting the rotary tool down.
WARNING:
Do not touch the blade
immediately after cutting, because it will be
hot enough to cause burns.
ASSEMBLING THE LED WORKLIGHT
This rotary tool is equipped with a free-
standing LED worklight that can be placed
on any flat surface near the workpiece.
The flexible arm can be bent in order to
focus the light on the desired location.
Install the batteries into the base of the
LED worklight as follows:
1. Turn the worklight upside down.
2. Remove the battery cover (1) from the
base of the worklight (2) by lifting the side
where the slot (3) is located (Fig. 17).
3. Install two AAA alkaline batteries (4) into
the battery compartment.
NOTE: Position the batteries with the
positive (+) end of each battery as
illustrated in the picture that is in the
battery compartment.
4. Re-install the cover of the battery
compartment.
5. Turn the LED worklight on or off using
the ON/OFF button (5) that is located on
the top of the base (Fig. 17A). Push the
button once in order to turn the light on.
Push it again to turn the light off.
!
!
ASSEMBLY AND OPERATING INSTRUCTIONS
Fig. 17
Fig. 17A