MasterCraft 54-4790-6, Руководство пользователя

Страница: 7 / 39

7
WARNING:
For safety reasons,
read this Owner's Manual carefully and
understand it thoroughly before
plugging in the rotary tool.
Hold the tool by the insulated gripping
surfaces when performing any operation
where the cutting tool may coming into
contact with hidden wiring or its own power
cord. Contact with a “live” wire will make
the exposed metal parts of the tool “live”,
which could shock the operator.
Verify that the work surface is free of nails
and other foreign objects. Cutting into a
nail may cause the bit and the tool to jump,
and could damage the bit.
Do not hold the workpiece in one hand and
the tool in the other hand while using the
tool. Do not place the hands near or below
the cutting surface. It is much safer to
clamp the material and to guide the tool
using both hands.
Do not lay the workpiece on a hard surface
such as concrete, stone, etc. The
protruding cutting bit may cause the tool to
jump.
Wear safety goggles and a dust mask.
Work only in a well-ventilated area. Using
personal safety devices and working in a
safe environment reduces the risk of injury.
Verify that the collet nut and all other
adjustment devices are securely tightened
after changing bits and accessories or
making adjustments. Loose adjustment
devices may be thrown violently when the
tool is turned ON.
Be sure to use the correct collet size. If the
collet size is larger than the accessory's
shank, it will not grip the shank properly,
which could result in injury to the operator
or damage to the tool.
Inspect accessory bits, grinding stones,
cut-off wheels, etc. for damage before
each use. A damaged accessory can
break during use, which could cause
serious injury.
Do not use dull or damaged bits. Handle
sharp bits with care. A damaged bit can
snap during use. A dull bit requires more
force in order to push the tool, which could
cause the bit to break.
Do not touch the bit during or immediately
after use. After use, the bit is hot enough
to burn bare skin.
Do not operate the flexible shaft with a
bend radius of less that 6” (15.2 cm). A
shorter bend radius will damage the
flexible shaft and the motor of the rotary
tool.
SPECIFIC SAFETY RULES
!