MasterCraft 54-4790-6, Руководство пользователя

Страница: 24 / 39

24
INSTALLING THE ANGLE GUIDE
– cont’d
4. In order to set the cutting angle, loosen
the two angle-adjusting thumb screws (4)
that are located on the sides of the base,
move base to desired angle, and then
retighten the thumb screws.
NOTE:
Do not overtighten the thumb
screws.
5. In order to set the cutting depth, loosen
the height-adjusting thumb screw (5), slide
the tool up or down in the base until it is at
the desired cutting depth, and then
retighten the thumb screw.
6. When working with dusty applications,
attach a vacuum to the vacuum adaptor (6)
(Fig 8A). In order to install the vacuum
adaptor, insert the small end of the adaptor
(7) into the vacuum port (8) that is located
on the side of the angle guide.
NOTE:
Align the two slots (9) in the
vacuum adaptor with the corresponding
keys (10) in the vacuum port. Turn the
vacuum adaptor clockwise in order to lock
it in position.
INSTALLING THE SANDER
ATTACHMENT
1. Remove the collet nut (1) and the collet
from the motor shaft (2) (Fig. 9).
NOTE:
Engage the spindle lock button in
order to hold the spindle in place while
loosening and tightening the collet nut.
2. Remove the spindle nut (3) from the tool
by turning it counter-clockwise.
ASSEMBLY AND OPERATING INSTRUCTIONS
Fig. 8
Fig. 9
Fig. 8A