MasterCraft 54-4790-6, Руководство пользователя

Страница: 23 / 39

23
INSTALLING THE RIGHT ANGLE
ATTACHMENT
– cont’d
NOTE: Rotate the right angle attachment
collet nut (12) while pushing the right angle
attachment onto the adaptor until the
square end of the drive shaft is inserted
into the corresponding square in the right
angle attachment.
8. Once the drive shaft is fully engaged
into the right angle attachment, lock the
right angle attachment to the
adaptor by turning the adaptor collar
clockwise.
NOTE:
Tighten by hand only. Do not use
pliers or a wrench.
Follow the basic procedures that are
described in the section entitled Changing
the collet and accessories in the flexible
shaft (Fig. 4) in order to change the collet
and accessories in the right angle
attachment. In order to lock the spindle,
rotate the collet nut (12) until the L-key
(13) can be inserted into the hole in the
shaft (14) (Fig. 7A).
INSTALLING THE ANGLE GUIDE AND
THE VACUUM ADAPTER
The angle guide is used to hold the tool at
a specific angle while cutting or grinding.
1. Remove the spindle nut (1) from the tool
by turning it counter-clockwise (Fig. 8).
2. Install the appropriate bit in the rotary
tool (Fig. 2).
3. Install the angle guide (2) onto the tool
by turning the base clockwise onto the
threaded portion of the tool spindle (3).
NOTE:
Do not overtighten.
ASSEMBLY AND OPERATING INSTRUCTIONS
Fig. 7A
Fig. 8
Fig. 7