Maserati Quattroporte, Руководство пользователя

Страница: 53 / 328

2
51
Understanding the Vehicle
that is being programmed to the
HomeLink
® system.
Before starting programming it is
necessary to erase the standard codes
memorized on the HomeLink
®
device
during the production phase. To erase
such codes:
• place the ignition device in the
RUN
position without starting the engine;
• press and hold the two outside
HomeLink
®
buttons (I and III) until
the warning light starts flashing
(after approximately 20 seconds);
• release the buttons.
NOTE:
• Erasing the standard codes
should only be performed when
programming HomeLink
®
for the first
time. Do not perform this operation
to program additional buttons.
• If you have any problems, or
require assistance, please call
toll-free 1
–
800
–
355
–
3515 or, on the
Internet at www.HomeLink.com for
information or assistance.
System with Devices Provided
with Rolling Codes
Programming the Hand-held
Transmitters Manufactured after 1995
These devices can be identified by the
"LEARN" or "TRAIN" setting button
located where the hanging antenna
is attached to the garage door/gate
opener. It is NOT the button that is
normally used to open and close the
door.
The name and color of the button may
vary by manufacturer.
• Place the ignition device to the
RUN
position without starting the engine.
• Place the hand-held transmitter 5
- 30 cm (1 to 3 inches) away from
the HomeLink
® button you wish to
program.
• Simultaneously press the Homelink ®
button you want to program and the
hand-held transmitter button.
• Release immediately the Homelink ®
button you want to program.
• Continue holding the hand-held
transmitter button until the warning
light starts flashing quickly; then
release the button.
The quick flashing light indicates that
the channel with the new frequency
has been acquired and programmed
correctly by the HomeLink
® system.
NOTE:
The distance necessary between the
portable hand-held transmitter and
the HomeLink
®
in the vehicle depends
on the system you wish to program.
Probably it will be necessary to try
several times. Upon every attempt,
keep the setting position for at least
15 seconds before trying again.
Synchronising the Rolling Codes
At the end of the previously-described
programming, if the HomeLink
®
has been programmed for a rolling
code system, it will be necessary to
synchronise it to ensure its correct
operation.
• Locate the "LEARN" or "TRAINING"
setting button of the opening motor.
Firmly press it and then release it. On
some garage door openers/devices
there may be a light that blinks when