Maruyama SSD600, Руководство по эксплуатации

Страница: 28 / 52

27 27 27 27
Spray pump
This pump is used to suction and pressure-feed
chemical in the main tank (chemical tank).
Caution
Pressure adjustment dial
This pressure adjustment dial is used to adjust
the discharge pressure of the spray pump. Turn
the pressure adjustment dial clockwise to raise
the pressure, or turn it counterclockwise to lower
the pressure. The discharge pressure can be
checked on the pressure gauge.
Water distributor/spray cock
Chemical is sprayed from the nozzle when the
spray cock on the water distributor is turned to
the “Open” position, and spraying stops when
the cock is turned to the “Close” position. The
left-side nozzle and right-side nozzle can be
operated separately.
An auxiliary spray cock is also available. You
can connect existing nozzles you may have.
(The hose diameter is 8.5 mm, and the thread
size is G1/2.)
To stop spraying or end the spraying
session, turn the pressure adjustment dial
counterclockwise until it stops, to lower the
pressure, and then turn off the PTO.
Be sure to use the PTO of the tractor at a
speed of 540 min
-1
.
If the PTO speed is too high or too low,
uneven spraying or spray pump
malfunction may result.
After every 100 hours of operation, put
around 3 to 5 drops of oil (SAE 10W-30 SH
class or higher) into the three holes (oil
filler ports) shown in the figure.
Close
Open
Spray pump
Pressure gauge
Pressure adjustment dial
Auxiliary spray cock
Right-side cock Left-side cock
Water distributor
Oil filler port
Oiler