Maruyama SSD600, Руководство по эксплуатации

Страница: 23 / 52

22 22 22 22
Adjusting the Sprayer Tread/Height
The tread of the machine can be adjusted by
changing the position at which the axle is locked.
Also, the height of the machine can be adjusted by
changing the direction in which the axle is locked.
Use the machine by adjusting its tread and height
according to the shape of the field.
To adjust the tread and height of the machine,
remove the machine from the tractor and set it down
on stable, flat ground, and make sure the main tank
(chemical tank) is empty.
(a) Changing the tread
[1] Chock the tires on the side opposite the
adjustment side (refer to page 3).
[2] Slowly lift the machine with jacks at the
jack-up points in the rear.
[3] Loosen the lock nuts on the bottom and side
faces of the axle bracket, and loosen the
bolts.
[4] Move the axle to a desired position. Confirm
that the dimple on the side face of the axle
is aligned with the check window.
Be sure to lock the axle at the same position
on the left and right.
Warning
Be sure to insert the axle until the label is no
longer visible. If the axle is not fully
inserted, it may come off and cause an
unexpected accident.
[5] Tentatively tighten the bottom bolt on the
axle and securely tighten the side bolt. Then,
securely tighten the bottom bolt. Lastly,
tighten the lock nut.
Bottom face: Torque: 60 N•m
Side face: Torque: 45 N•m
Slowly lower the jacks.
[6] Change the axle locking position on the
opposite side by following steps [1] to [5].
Warning
Be sure to secure the axle with four bolts on
the bottom and side faces of each axle
bracket.
If the axle is secured with loose bolts, it may
come off and cause an unexpected accident.
Jack-up points
Side bolts/lock nuts
Axle bracket
Bottom bolts/lock nuts
Check window
Label