The Advantage Series Installation
Page 24
MDE-3883 TRIND Retrofit Kits C00011-005
• 10/00
PRELIMINARY
FCC 11/30
2
Route R20773-G2 cables around board as shown for both wide and narrow frame
units, securing cable to board with tie-wrap.
3
Route A side cable R20773-G2 along door with clamps provided with kit until
connector end is fed through clamp inside door. Do the same for B Side cable.
4
Route A side card cage harness cable (with P1 connector) to door clamp, and
connect to A Side R20773-G2 cable at P1/J1.
Note: Card cage harness cables were positioned for installation in Step 7 of
“Installing Card Cage” on page 21.
5
Route B side harness cable (with P2 connector) through clamps above CRIND
tray to cable clamp inside door, and connect to B Side R20773-G2 cable at P2/J2.
Note: When routing from cabinet to main door, allow sufficient slack in cables to
allow main door to open and close without pulling or crimping cables or
crimping cables when door is closed.
6
Reinstall sheet metal cover on door, being careful to avoid crimping cables.
7
Proceed to “Connecting Remaining Cables” on page 31.
tie-wrap
R20773-G2
J182
Cable clamps provided with kit
R20773-G2 cable
Cable clamp inside door
