MDE-3883 TRIND Retrofit Kits C00011-005
• 10/00
Page 23
The Advantage Series Installation
PRELIMINARY
3
Position card cage so that tab fits over latch cutout for main door latch, securing
card cage to shelf divider.
• If two screws on card cage pass through shelf secure from underside of shelf
with two nuts provided in kit.
• If screws were removed, secure card cage from underside of shelf by installing
one screw removed in section “Prepare T20606-G3 card cage for installation.”
on page 21 up through hole in shelf to clinch nut on card cage (see illustration
above). Dispose of second screw and two nuts.
Installing Right Option Door
Install new right options door according to the following steps.
1
If sheet metal shield has not been previously removed, using 1/4’’ nut driver, remove sheet
metal shield from back of door. Refer to illustration in “Modifying Right Options Door On
Wide Frame Units” on page 16 for detail. Save cover and hardware.
2
Remove key taped to inside of new right options door and save.
3
Position new right options door and install with pin removed with old door and
saved.
Note: If unit had stop or call button transferred from old door to new TRIND door,
reconnect stop or call button wires to contact block.
4
For narrow frame units, reconnect existing cables to new door PPU and main
display.
Route cables to Right Option Doors
1
Connect J182 on one R20773-G2 cable to A Side Light/Microreader PCB at P182, and do the
same for B Side.
Tab locks into shelf divided at latch cut-out