MDE-3883 TRIND Retrofit Kits C00011-005
• 10/00
Page 25
MPD-3 Series Installation
PRELIMINARY
FCC 11/30
MPD-3 Series Installation
Removing Faceplate
MPD-3 units have two types of faceplates; slide-in (PMI bezel) and bolt-on (Mack
bezel). Follow directions for the type of faceplate and bezel that applies.
For units with slide-in faceplates on PMI bezels, do the following:
1
Release right side faceplate using keyswitch.
2
Open manager keypad door and remove single screw.
3
Gently force faceplate up, and slide tip of knife or flat blade screwdriver under
bottom edge of faceplate.
4
Pry bottom of faceplate away from unit, until faceplate can be removed from unit.
Dispose of faceplate.
For units with bolt-on faceplates on Mack bezels, do the following:
1
Open bezel door and lift until door is latched open.
2
Disconnect cable between manager keypad and logic board on bezel door. Discard
cable.
3
Locate six sets of nuts and washers securing faceplate to bezel studs, and remove
hardware.
Note: This may require removing mounting hardware from price per unit (PPU)
and CRIND™ logic boards to gain access.
Screw
Stud locations behind faceplate
Stud locations behind faceplate
Faceplate stud locations
on Mack bezels
