MDE-3883 TRIND Retrofit Kits C00011-005
• 10/00
Page 31
Connecting Remaining Cables
PRELIMINARY
FCC 11/30
Connecting Remaining Cables
1
From A side, pass J250 end of cable R20437-G01 through card cage to B side.
2
Connect J250 on ribbon cable R20437-G01 to P250 on Gateway PCB T20678-G1
in card cage (on T20606-G3 card cages) or on top of card cage (T20606-G4 card
cages).
From A side of unit make the following connections:
1
On ribbon cable R20437-G01, connect J258A to P258 on A side CRIND Logic Board.
Note: A side of split cable R20437-G01 has red wire.
2
On ribbon cable R20437-G01, connect J258B to P258 on B side CRIND Logic
Board.
Connect R20580-G1 power cable according to the following:
Note: Connections are unit specific. Use appropriate connectors to intercept power
by installing R20590-G1 inline. Refer to “Cable Block Diagram” on page 37.
For units with:
Do the following:
System cable W02468
Install inline using 15 pin P601 and J601 connectors
System cable T19612
Install inline using 3 pin connectors J601/J708 and P601/P708
P250 on
T20678-G1
PCB
