Manitou Systems 160 ATJ, Руководство оператора

Страница: 95 / 131

3 - 21
D8/1
D8 - H
YDRAULIC OIL
EMPTY - REPLACE
- Set the platform on a horizontal surface with the engine stopped.
EMPTYING THE OIL
- Set a receptacle under the drain plug 1 (Fig. D8/1) and loosen the collar 2
(Fig. D8/1).
- Remove the drain plug 1 (Fig. D8/1).
- Remove the filling cap 3 (Fig D8/2) to assist drainage.
CLEANING THE SIEVE
- Remove the sieve 5 (Fig. D8/2) by pulling it upwards and clean it with a jet
of compressed air.
- Re-insert the sieve.
FILLING WITH OIL
Use a receptacle and a very clean funnel and clean the top of the oilcan
before filling.
- Re-insert and tighten the drain plug 1 (Fig. D8/1).
- Fill the reservoir completely with hydraulic oil (see the LUBRICANTS
section) through the filling hole 4 (Fig. D8/2).
- The oil level should be above the red mark on the gauge 6 (Fig. D8/3).
Dispose of the drained oil in an environmentally friendly manner.
D9 - C
ONDITION OF HOSES
CHECK
- Check the visible condition (splitting) of the hoses, subject to thermal stress
and UV. Their technical characteristics may be altered (porosity).
BE CAREFUL OF LEAKS
Hydraulic oil escaping at high pressure can penetrate the skin and
cause serious lesions. In the event of injury caused by a jet of
pressurized oil, consult a doctor immediately.
If in doubt as to the presence of a leak, do not search for it with your hand,
but use a piece of cardboard and protect your hands and body.
For your own safety, replace worn hoses.
D8/3
D8/2
1
2
6
3
5
4