Manitou Systems 160 ATJ, Руководство оператора, Страница: 88 / 131

3 - 14
C6
1
C6 - O
IL LEVEL IN FRONT AND REAR WHEEL REDUCERS
CHECK
Set the platform on a horizontal surface with the engine stopped.
- Check the level on each of the front wheel reducers.
- Set the plug 1 (Fig. C6) horizontal.
- Remove the plug. The oil should be flush with the hole.
- Add oil if necessary (see the LUBRICANTS section) through the same
hole.
- Re-insert and tighten the plug 1 (Fig. C6) (tightening torque 8 daNm).
- Repeat the operation for each rear wheel reducer.
C7 - T
IGHTENING WHEELNUTS
CHECK
- Check the tightness of the wheel nuts (Fig. C7)
Failure to do this can cause the wheel pins to deteriorate and break and the
wheels to deform.
C8 - B
ACKUP PUMP
CHECK
- Stop the I.C. engine
Make sure the backup pump is working properly by pressing the switch
beside the base control box or the basket control box.
- Perform an arm lowering movement (example…)
You must not use the platform if the pump is not working.
C9 - L
OCKING THE TELESCOPE
CHECK
- Make sure the 16 nuts on telescope 1 wear pads are tight (Fig. C9/1 and
C9/2).
Failure to follow this instruction may lead to the pads being lost and the
telescope could be damaged.
34 daN.m
± 15 %
34 daN.m
± 15 %
C7
WHEEL TORQUE
NUTS LOADING
FRONT WHEEL
REAR WHEEL
C9/2
1
C9/1
1
1
1
1
1
1
1
1
1
1
1
1
1
1
1