MANATEC JUMBO HCV, Руководство по эксплуатации

Страница: 6 / 135

Ref.: MEL-WA(3D HCV) - OM Ver.1.7
1
1. WARRANTY
– STATUTORY CLAUSE
Equipment is provided with one year Warranty from the date of installation or thirteen months
from the date of dispatch which ever is earlier (International warranty up to fifteen months from
date of dispatch) against any manufacturing defect. Warranty is subject to following conditions:
1.
Ensure that proper power supply with protective Earthing is provided to equipment. Any high
voltage may damage the components, leading to system failure or electrical hazards.
Power supply:
230V operation: Single Phase, 230V AC ± 10%, 50/60 Hz + N + PE (or)
110V operation: Single Phase, 110V AC ± 10%, 60/60 Hz + N + PE
(The Potential difference between N
– Neutral & PE – Protective Earth should be below
3V)
Laser printer should be connected in a separate power supply. Machine power socket
should not be used for this purpose. The Laser printers consumes more power.
Warranty ceases if this condition is not satisfied
2. Power supply to the equipment should be connected only through a CVT of 1KVA capacity
and then through an UPS of minimum 1KVA capacity with AVR (Automatic Voltage Regulator)
circuit. The system must be shut down before the UPS power trips OFF (due to limited battery
backup time). Failing to comply may lead to operating system / software corruption.
Warranty ceases if this condition is not satisfied
3. Do not attempt to open or service the equipment under any circumstances. Risk of electric
shock may happen. Only authorized / qualified service personnel should trouble shoot the
equipment.
Warranty ceases if the equipment is opened/tampered or serviced by un-authorised
personnel
4.
Warranty ceases if this equipment is used for any purpose other than intended use.
5. The equipment must be installed Indoor away from direct Sunlight or reflected Sunlight
through any object or rain / moist areas.
Warranty ceases if the equipment is exposed to Sunlight, Rain / Water
6.
Do not attempt to load any other Application software (Audio, Video etc.) under any
circumstances, other than the alignment program loaded in the Factory.
Warranty ceases if the system is loaded with any other Application software
7. If transportation, lifting, unpacking, installation, assembly, start up, testing, repair and
maintenance have been performed by un-authorised personnel, the manufacturer shall not be
responsible for injury to personnel or damage to objects.
8.
DO NOT remove or modify any parts of the equipment as this could compromise the
equipment
‟s intended use. For any modifications / repairs consult the Manufacturer.
9.
The Vehicle specification data must be entered by End user only. MANUFACTURER IS NOT
RESPONSIBLE FOR ANY INCORRECT OR INCOMPLETE VEHICLE SPECIFICATIONS
ENTERED INTO THE SYSTEM
. No claim is entertained for any damage or loss.
10.
Follow the Alignment lift manufacturer‟s safety recommendations when lifting a vehicle.
MANUFACTURER IS NOT LIABLE FOR ANY DAMAGES CAUSED due to non-
compliance
11.
Make the warranty registration by duly signing the Installation, Commissioning & Training
report.
Manufacturer does not warrant third party products / software added to our Wheel aligner
through our Factory integration system. The below listed Third party products / peripherals /
software are covered under the warranties provided by the respective OEM. Third party
manufacturer
‟s warranty may vary from product to product. Consult the respective product
documentation for warranty information:
1. Desktop computer with Monitor
2. Printer
3. Keyboard
4. Mouse
5. Multimedia speakers
6. Operating system software