MANATEC JUMBO HCV, Руководство по эксплуатации

Страница: 44 / 135

Ref.: MEL-WA(3D HCV) - OM Ver.1.7
39
Calibration kit is a simplified tool meant for calibrating the all the Target plates
simultaneously and if necessary to correct it.
Calibration is a very important function. During this process, the
Calibration stand should not be jerked or moved during calibration
process
6.10.14. HCV ROTARY PLATE, SLIM TYPE
This HCV Rotary plate with slim design facilitates proper measurement &
adjustment of Toe angle in HCVs with Pusher axle while conducting alignment
on a rough surface.
Fig. 59
6.10.15. HCV ROTARY PLATE RAMPS
Front Ramp Rear Ramp
Fig. 60
Ramps are provided to facilitate Push-Pull (Roll-On) Runout wherever recess
(Pit) is not available for Rotary plates in the Alignment bay. Ramps are to be
located at Front side and Rear side of Rotary plates so that the Vehicle can be
rolled forward / backward easily over the Rotary plates placed over a plain
surface. The Front and Rear Ramps are to be placed near the Rotary plates
as shown below:
Fig. 61
The Rotary plate ramps must be maintained properly by user free
from dust
6.10.16. WINCH (5443kg)
The Winch can be used for measuring Wheel runout accurately in Articulated
buses wherein the Vehicle drive (Engine drive) on this particular bus is
generating too much axle jerks without load and the drive axle slippages on
the ground is noticed. The axles are not rolling, instead it is slipping and the
wheels alone turns backwards and the targets are flipped back from the
camera views. This winch is operated using 12VDC. The winch has a DC
motor with gear box and a spool with steel wire rope wounded on it.
F1 Rotary
plate
F2 Rotary
plate
Front
ramp
Front
ramp Rear
ramp