MANATEC JUMBO HCV, Руководство по эксплуатации

Страница: 58 / 135

Ref.: MEL-WA(3D HCV) - OM Ver.1.7
53
7.4.2.1.
CUSTOMER DATA INPUT
After Vehicle selection, following screen will be displayed:
Fig. 85
Enter required input. All the above data will be recorded in the
Alignment report which can be printed after completing alignment.
While feeding the customer data, the machine will be searching the
targets in the background of the program. Therefore, the camera
vision path should not be obstructed by any objects / person
movements.
System will not proceed further without input of Vehicle
Registration number in
Customer data input screen
Customer data or Vehicle specifications can be edited or
selected respectively between "
Initial measurement
completed" and " Alignment completed " screens
Press NEXT SCREEN after entering all the data.
In Push-Pull (Roll-on) Runout, Vehicle should be driven towards backward
slowly with engine drive by 30°. The screen will guide the operator where to
stop the vehicle. Once the readings are acquired at 30° position, the screen
will guide to drive the vehicle forward to reach its home position.
Press NEXT SCREEN button to proceed. The system will identify the Target
plates mounted on the wheels as shown below:
Fig. 86
Once the Target plates are identified, the following screen will be displayed:
Truck with
2 Front axles & 3 Rear axles
Truck / Bus with
1 Front axle & 1 Rear axle
Trailer With 3 Axles (Forward parking) Trailer With 3 Axles (Reverse parking)