MANATEC JUMBO HCV, Руководство по эксплуатации

Страница: 56 / 135

Ref.: MEL-WA(3D HCV) - OM Ver.1.7
51
(iv) B2 Axle specification:
Fig. 82
(V) B3 Axle specification:
Fig. 83
Check the condition of each parameters of the Vehicle and select the
required data to record in the Alignment report.
In case of HCVs with Multi-axles, Check & ensure the Frame
gap of both Left & Right sides are equal or within a
difference of 5mm. If not, achieve the same by loosening the
„U‟ clamps and re-fitting it in the work shop:
Press NEXT SCREEN button to conduct Wheel Runout . Press PREVIOUS
SCREEN button to go back to previous screen.
7.4.2. WHEEL RUNOUT
The purpose of this program is to find out the Wheel Runout (wobbling) and
effect the "Runout compensation" automatically in the subsequent programs
while Camber and Toe are measured / adjusted.
While doing Runout, do not jerk the Vehicle or the Target plates which
may cause abnormal Runout. Ensure Steering lock is fixed firmly to
avoid unwanted steering rotation.
Ensure the Vehicle is in neutral position with Hand brake released
Lock the Rotary plates with Locking pins before parking the Vehicle
over the Rotary plate. The rotary plate spacers must be placed
LFG
–
Left Frame Gap
RFG
–
Right Frame Gap