MANATEC JUMBO HCV, Руководство по эксплуатации

Страница: 122 / 135

Ref.: MEL-WA(3D HCV) - OM Ver.1.7
117
By selecting this option, screen displays the following Data sheet in
which the details of specifications are to be filled:
The user has to keep ready all these information before starting to
add any Vehicle specifications.
1. VEHICLE MAKE
Type Vehicle makes and press ENTER to go to the next
window.
2. VEHICLE MODEL
Type Vehicle model and press ENTER to go to next window.
3. TOE IN DEGREES / MM / INCHES (D,M,I) ?
The TOE values of the vehi
cle can be entered in “degree” (or)
“mm” (or) “inch”. To intimate the system about the TOE input
unit, enter "
D " for Degrees, " M " for mm and " I " for inches.
Press ENTER to move to next window. This window cannot be
left blank. A beep sound will be heard it attempted.
4. RIM DIAMETER
If the Toe unit is entered as “mm” or “inch”, then the Rim
Diameter of the vehicle has to be entered. If this window is not
filled, the system will not allow you to proceed further.
Alignment specifications
Each and every angle has been provided with four data entry
windows. First two for the Front wheels and other two for Rear
wheels. Two windows are given for each wheel to enter the
Maximum and the Minimum permissible reading.
5. CASTER
Enter the Minimum allowable Caster for that vehicle in first data
window. Enter the Maximum allowable Caster in second
window. As Caster is not applicable for Rear wheels, system
will prompt "N/A" in the other two Rear wheel windows, so you
can't enter any data in these windows.
6. KINGPIN
Follow the same procedure as done in Caster. Kingpin is also
not applicable for Rear wheels, so "N/A" will be displayed in the
Rear wheel windows.
7. CAMBER
Enter Camber readings as per procedure for both Front & Rear
wheels.
8. TOE
There are three options for entering Toe readings. Any one of
the options can be chosen according to the requirement. i.e., if
'D' is entered in "Toe in degree / mm / inch (D,M,I) ?" Data
window, then Cursor will be taken to Toe in Degrees Data
window. If "M" is entered, then the cursor will be placed in the
Toe in MM data window and for "I", it will be Toe in Inches data
window. The windows other than the selected will have "----".
If the Toe / Total Toe values are entered in "mm" "Inches",
the system will convert it to "degree & minutes"
If Toe values are entered first, then Total Toe will be
calculated by the system itself from the entered Toe value &
displayed in Total Toe window and vice versa if Total Toe
value is entered first