MANATEC Fox 3D Smart Mobile PT, Руководство по обслуживанию

Страница: 64 / 104

Ref.: 3DWA - SM Ver.1.8
61
6. Insert the Cross pipe (with middle bush) into the hollow end of another
Cross pipe and lock the assembly using Dowel pin as shown below:
Fig. 108
7. Locate the Stepped pins into the front & rear side LH shaft mounting
blocks (ie., diagonally) as shown below and then locate the Cross pipe
assembly with the diagonally placed Stepped pins:
Fig. 109
Fig. 110
Fig. 111
8. Use Arm locking knob to lock the Target plates during calibration.
9. Ensure the height of Calibration shaft at all the corners are maintained
evenly before proceeding with calibration.