MANATEC Fox 3D Smart Mobile PT, Руководство по обслуживанию

Страница: 61 / 104

Ref.: 3DWA - SM Ver.1.8
58
7.2. FLOOR CALIBRATION
In case of Lift, rest the platform at home position to carryout Floor calibration
This feature is used to compensate uneven level on the Pit/Lift. Select FLOOR
CALIBRATION from Calibration menu. Two status buttons are provided to Enable /
Disable this feature, which will be indicated with

mark /

mark respectively. Fix the
Target plates with Wheel bracket.
Place both the Front target plates over the respective Rotary plate center by resting the
Wheel bracket Rim locking pins over the surface as shown below & similarly place the
Rear target plates 2mtr away from Front target plates as shown in screen.
Fig. 97
Press NEXT SCREEN button to proceed further.
Try to make Front Left and Right distance equal. Same way make both Rear Left &
Right distances equal. Once the distances are made equal,
SAVE button appears.
Press SAVE button.
Fig. 98
7.3. SENSOR (DUAL AXIS) CALIBRATION
Use the Dual axis Sensor calibration kit to calibrate the sensor. Fix the entire PCB
assembly along with the plate as shown below (USB hub PCB + Sensor) on the
calibration Jig. Level the base plate in both X & Y direction using the jack screws
provided in the Base plate. Ensure the bubble level is at center of the two lines and
without any tilt in the base.
Connect the Sensor connectors CN4 (Y axis) & CN5 (Dual sensor output X axis is
labeled as Z axis) as shown below:
Fig. 99
CN4
CN5